 |
|
|
|
| |
|
|
|
| Phone: 01293 533 665 |
| Email: enquiries@thepumpco.co.uk |
|
|
| Domestic Pumps - Light Duty Monobloc - SAER CM-CMP |
|
 |
|
 |
|
| This series of electric single impeller close coupled centrifugal pumps are fitted with the overhang impeller directly splined keyway on to the motor shaft. |
|
| The liquid pumped is conveyed into the spiral shaped volute of the pump body transforming the kinetic energy into dynamic pressure energy. |
|
| Pressure and flow is achieved with minimum loss by means of the hydrodynamic closed impeller design. |
|
|
|
| Summary of Features |
|
| Single phase motors with a built in thermal overload protection on request, the capacitor is permanently in circuit |
| Motor protection to IP44 |
| Winding insulation to class B (for motors of size 63), F (for other sizes) |
| Standard voltage: 230V- 50Hz single phase, 230V/400V- 50Hz three phase. |
| Other voltages and frequencies available upon request |
|
| Applications |
|
| Industrial water supply, pressurized water using pressure vessels (autoclaves), horticultural and agricultural irrigation, civil and domestic water transfer applications |
|
|
| Operational Limits |
|
Capacities up to 8 m3/hr
Heads up to 59 meters
Liquid quality required clean, free from solids or abrasive substances and chemically non aqgressive.
Maximum Temperature of pumped liquid -15°C to +70°C
Maximum ambient temperature 40°C.
For higher temperatures please contact the sales office.
Maximum working pressure 9 bar.
The tolerances of the hydraulic features are according to UNI / ISO 2548-Class C, Appendix B, electric features according to C.E.I.
The working features listed in the catalogue are based on continuos service for clear water with a specific weight of 1000 kg /m3.
Manometric suction lift of 8 meters with a foot valve, for a suction lift of above 5 meters it is advisable to install the suction pipe with a internal diameter larger than the pump inlet. |
|
|
| Materials of Construction |
|
Pump body and motor support in cast iron or cast aluminum alloy. Pressed brass impeller or thermoplastic resin
Mechanical seal in carbon/ceramic
Rotor shaft fitted with seal for life bearings
Totally enclosed fan cooled motor (TEFC) |
|
|
|
| |
|
|
|
The Pump Company Limited, 22 The Bell Centre, Newton Road, Crawley, West Sussex, RH10 9FZ
Tel: (0)1293 533665. Fax: (0)1293 533664 Registered in UK 3428736 |
| |
|
|
|
|
